3D Printing
Last updated
Last updated
3D printing is a bit of a misnomer, Fused deposition modeling or fdm is much more practically Akin to Machining or woodworking rather than consumer level printing. The main reason is because it's far more likely to fail due to an inexperienced and then say clicking a button and expecting an object to magically appear. Of the hours and hours I've had to spend on this dumb fuckin’ machine, the quality and success of prints have been minimal.
if Cura isn't available
tram
flat
clean
gap
level heater
live level
tram
flat
clean
gap
level heater
live level
HOWtooooooo
HOWtooooooo
and firmware
and firmware